OMAP3 LVDS

Материал из YourcmcWiki
Версия от 23:09, 5 апреля 2011; VitaliyFilippov (обсуждение | вклад)

(разн.) ← Предыдущая | Текущая версия (разн.) | Следующая → (разн.)
Перейти к: навигация, поиск

Скопировано с LVDS on Rev B Beagleboard — Beagle Board | Группы Google


Matt Evans:

Hello,

I thought I’d share a little hack I put together back at the end of September for a Rev B Beagleboard, in case anyone’s interested.  I hadn’t got round to uploading the pictures at the time (and forgot   since then) but I think LVDS-on-Beagleboard will get get more topical   again this month with the release of the excellent RevC update with   the OMAP3 LCD outputs available.

So…

The aim of the project was to drive an LVDS TFT panel directly from   the Beagleboard, *without* first going to DVI, then externally   converting to LVDS (IMHO icky).  The LCD panel was an AUO B089AW01,   which is the 1024x600 18-bit colour TFT featured on several of the   netbooks available (e.g. Acer Aspire One).

General plan:

  • Remove TFP410 DVI serialiser.
  • Use buffers to step the 1.8V OMAP3 LCD outputs up to 3.3V.
  • Use a NatSemi DS90C363 LVDS serialiser to drive three LVDS pairs   (plus one clock) to the TFT panel.

Total cost:  about 10UKP of parts (3xSN74AVC8T245 octal buffers (dual   power rails), 1xDS90C363, misc connectors/passives) plus a small PCB   (homemade in kitchen with Iron-On™ toner transfer technology) plus   time.  (A lot of time.  You’ll see the soldering below; it was   enormously enormously time-consuming.)

So, it’s not pretty but it works, as the saying goes….  >:-)  Anyone   want to see?

Here’s the board:

LVDSBoard.jpg

Here’s the space once occupied by the TFP410, with 33 gauge wirewrap   wires being soldered on (apologies for the crappy picture quality).   The flux is making it look a little messy, but it cleaned up.

LVDSLoupe.jpg

The umbilical wires in place:

LVDSWires.jpg

Finally, the two welded together:

LVDSAttachedToBB.jpg

Naturally I forgot to take a final shot before it got whisked away abroad (d’oh! :)), but it worked splendidly.  I believe the prototype   photos of a certain OMAP3-based device announced this week are it in   action…..

Am looking forward to (I think Keith Williams’s) revC daughterboard.   One thing to note is that most LCDs will require a lot of current on   the 3.3V rail and will require an extra 3.3V power supply/regulator   from the BB’s 5V supply; software side of things was easy, and it was   a lot of fun.  :) Hope that is of some interest, Matt